POWERTEC Generator Set

Powered by Perkins 4016TAG2A Engine

Model：PPE2250 Prime Power: 1600KW/2000KVA Standby Power: 1800KW/2250KVA

Genset Fundamental Characteristics Genset Standard Configuration

◆ 230/400VAC，50HZ 0.8PF 3 Phases, 4 wires output ◆ Perkins Engine

◆ Frequency drop ≤3% ◆ Brushless synchronous alternator
◆ Voltage modulation ≤0.3% ◆ POWERTEC intelligent controller
◆ The steady state frequency ≤0.5% ◆ 40℃ standard ambient temperature
◆ The steady state voltage deviation ≤±1% Water radiator
◆ The transient frequency deviation ≤+10% ≤-15% ◆ Modularized case circuit breaker（3P）
◆ The transient voltage deviation ≤+20% ≤-15% ◆ Float Battery Charger
◆ Frequency recovery time ≤3S ◆ Battery connect wire
◆ Voltage recovery time ≤1S(Voltage±3%) ◆ Steel base frame(include shock absorbers )
◆ THF (Telephone Harmonic Factor) <3 ◆ Bellows、exhaust bend
◆ TIF (Telephone Influence Factor) <50 ◆ Manual book and files
Comply to Standard NEMA MG1-22.43
◆ Standard equipped with ambient temperature 40℃
Connecting radiator
◆ Inbuilt shock absorber has high performance on shock absorption.
It’s easy to be transported and installed without embedding and
Fixing rubber shock pad between the genset and ground

Genset Optional Configuration

◆ 24V Starter Batteries

◆ Daily Fuel Tank
◆ Oil-water separator
◆ Warning function of low water level, low fuel oil
◆ Automatically monitoring & controlling system of
City power
◆ Coolant heater
◆ Oil heater
◆ Heat exchanger--Water cooling Tower System
◆ Soundproof Canopy/ Trailer
◆ ISO container
◆ Design and construction of environmental protection
Engineering for the Genset room
1
 Equipment Instruction

Performance Description of Diesel Engine

◆ Model： Perkins 4016TAG2A
◆ Construction：Equiping with independent four valves cylinder head to facilitate air flow. The single fuel injector
ensures ultra atomization of diesel fuel and combust at high speed under full control. Sharing a large number of
components with other 4000 series engines helps to
reduce the inventory of the manufacture.
◆ Intake: Turbocharged
◆ Fuel system: Digital governor with isochronous function,
speed is adjustable to ISO8528-5 standard; direct
injection system with lift pump
◆ Lubrication system: Wet all aluminum oil pan with oil
injector and oil dip stick
◆ Cooling system: Two sets of double thermostat
◆ Filtration system: Embedded air filter and turbocharger;
rotary full-flow fuel filter; rotary full-flow oil filter
◆ Electrical equipment: 24V starter and 24V alternator,
built-in regulator (DC output); turbine inlet high
temperature protection switch; double coolant high
temperature protection switch;double low oil pressure protection switch
◆ Lower operating cost: The standard replacement oil interval is set to 500 hours
◆ Engine Operating Environment Description:
The engine can work under the following conditions without modulating power:
1800r/min engine--altitude less than 1000 m, ambient temperature less than 40 ℃
1500r/min engine--altitude less than1000 m, ambient temperature less than 40 ℃

Performance Description Alternator

◆ Optional Alternator: Stamford / Marathon/ Faraday/Engga/Mecc Alt

◆ Brushless, 4 pole rotating magnetic field, single bearing with
protective cove
◆ Insulation: H Class.
◆ Standard IP23 grade
◆ Cooling system
◆ AC exciter, rotate rectifying unit
◆ Surface of stator winding is covered with damp-proof epoxy
Insulation varnish after impregnation proceeding
◆ Rotor and exciter is proceeded with high temperature insulating
resin, Will be more applicable for harsh environment.
◆ Rotor dynamic balancing comply to standard BS5625,class 2.5
◆ Sealed with advanced lubricating grease prolongs life of bearing.

Notes: Above data of alternator comes from Stamford. Proper specification is subject to the practice
alternator if customers choose other alternator

2
 Intelligent Control System

Standard Detection Function

◆ 3 phases voltage Ua,Ub,Uc ◆ 33 phases
◆ phases current
current La,Lb,Lc
La,Lb,Lc
◆ Frequency F1 ◆ Active
◆ Active power
power PA
PA
◆ Apparent power PR ◆ Power
◆ Power factor
factor PF
PF
◆ Coolant temperature WT ◆ Temperature ℃
◆ Temperature ℃ display
display
◆ Oil pressure OP ◆ KPa/Psi/Bar
◆ KPa/Psi/Bar display
display
◆ Speed RPM ◆ Battery
◆ Batteryvoltage
voltageVV
◆ HC timer 99999 hours records
◆ Maximum cumulative times of starting can reach 999999

Standard Protection Function

Genset Protection
◆ Programmable alarm and status input ◆ Emergency stop
Engine Protection
◆ Stop for over speed ◆ Alarm for low/high battery voltage
◆ Alarm/Stop for low oil pressure ◆ Alarm for shortage of battery
◆ Alarm/Stop for coolant high temperature
◆ Stop for failure to start/jigger
◆ Indication of sensor fault
Alternator Protection
◆ Stop for over high/low voltage ◆ Stop for over frequency
◆ Alarm/stop for over current ◆ Stop for low frequency
◆ Stop for loss of voltage detection signal
Control System Components
◆ Control switch—manual/auto/stop/start
◆ Screen menu selection button
◆ Setting button ◆ Emergency stop button
◆ Fault status indicators ◆ Digital display

Communication Interface （optional function）

InterfaceCommunicatio
◆ International standard MODBUS communication protocol with error detection as well as RS232/ RS485 (RS485 is
n has functions of remote control, telemetry and telesignalling, which are facilitate to monitor
opto-isolated type)
Interface
genset. Communication

Interface
Notes: Above data of controller comes from POWERTEC GC6110. Proper specification is subject to customers’
practice controller if other controller is selected.

3
Data sheet of Genset

Model PPE2250
Prime Rating (kw) 1600
Genset
Standby Rating (kw) 1800
Prime current(A) 2887
Frequency(hz) 50
Engine Model 4016TAG2A
Gross Engine output-Prime (kw) 1715
Gross Engine output-Standby (kw) 1886
Bore * stroke (mm) 160*190
Cylinders and structure 16 V type
Displacement(Liter) 61.12
Compression Ratio 13.6:1
Turbocharged/ Air-Air
Intake way
intercooler
Max intake resistance (KPa) 2.5
Air intake (m3/h) 8220
Max exhaust back pressure (KPa) 3
Exhaust gas flow (m3/h) 23220
Exhaust temp (℃) 493
Cooling way Water Radiator & Fan
Fan exhaust flow (m3/min) 2430
Coolant capacity (L) 316
Highest water temperature(℃) 98
Engine & Alternator
Minimum air opening to room (m2) 10.0/9.0
Thermostat range (℃) 71-85
Max oil temperature (℃) 105
Lubrication system oil capacity (L) 237
Fuel consumption(L/H) 434
Standard Governor/Class Electronic
Marathon--- MX-1800-4
Engga------- EG500-1800N
Optional Alternator Model
Stamford---- PI 734F
Faraday----- FD7F1-4
Rated Voltage(V) 400/230
Output Way 3 Phases, 4 wires
Rated power factor 0.8
Exciter Brushless, Self-exciter
Max voltage regulation ±1%
Phase 3
Protection class IP21-23
Insulation class H
Controller Brand and Model POWERTEC GC6110

4
Dimension and Weight

Dimension mm Weight Fuel Tank Capacity

Type
（L*W*H） KG L
Open Type 6650*2300*2562 14361 -

Silent Type - - -

Notes:：Above data are for reference only. Specific size is subjected to actual measurement.

Contact Way Powertec Generator System Co., Ltd

Add: Danshui Yanna Industry Zone, Huiyang, Huizhou, Guangdong, China

Tel：0752-3911119 / 0752-3911118

FAX：0752-3911110

Web：www.powertec.com.cn Email：sales@powertecgs.com