Installation Instructions

F
C

F C

I C
K
E G
C
K

J I
I

H K
I B
J

×2
 A×1 B×1 C×4 J×4

D×1 G×1

H×1

E×1 I×8

K×4 T×10

F×4 L×4 M×8

N×4 O×4 P×22 Q×4 R×78 S×8

step1 Insert the 4 parts F into the four short tubes extending from part A and secure with the 4 bolts P.

Note : the larger holes on part G should overlap the holes on the extensions from part A.

（front）

A
（back）
F
P
（front）

（back）

P×4

step2 Insert the other ends of the 4 parts F into the four short tubes extending out from part B and secure them
with the 4 bolts P.

（front）
B

P
（back）

P×4
step3 Place the base panel E into the cabinet from the bottom and align the holes located around the
bottom frame, secure with 12 screws R.

（front）

（back）

R×12
Place part G with the 6 holes side up, then place 2 parts K on part G and align the
step4 holes, secure with 4 screws R.

Place part H with 6 holes facing up, place 2 parts K on part H and align the
R holes, secure with 4 screws R.

H R×8
step5 Lift the cabinet frame and place the assembly G from the rear so that it lines up with the holes in the
center of the frame and secure it with 2 sets of bolts N and nuts O.

（front）

（back）

O N×2 O×2

step6 Place part H on the front frame of the cabinet so that it lines up with the hole in the center of the
frame and secure it with two sets of bolts N and nuts O.

（front）
H

（back）

O
N×2 O×2
step7
Place the two parts C together and use bolts and nuts to secure them to become half of the back wall of the cabinet.

×2

C
C

×2

P Assemble the other two parts C in the same way.

Q
P×4 Q×4

step8 Place the rear wall assembled in the previous step into the cabinet from the back and secure with 8 screws.

Note: The bent edge is facing outward.

（front）

R
（back）

R
R×8
step9
Install the other back panel in the same way.

（front）

（back）

R×8

step10 For ease of assembly, lay the cabinet flat on the floor with the front facing up.
Place the top plate ( Part D) from above, aligning it with the top edge of the frame, and then use ten
hinges T to connect the top plate to the cabinet with ten bolts P (to attach the top plate) and ten
screws R (to attach the cabinet).

（front）

（back）

R T

P P×10 R×10 T×10

 Install the 8 hinges (part I) in the locations as shown and secure in place with screws R.
step11

I I

R
R

R×16

step12
Insert magnets S.

Secure the handle L to the

door with two bolts M.
S
L M
×4

S
L×4 M×8 S×8
step13 Align door panel K with the two hinges on the left side panel and secure with four screws.

R×4

step14 Install the other three door panels in the same way.

R×12