GENERAL NOTES
1. General building code.
· This drawing is to be read in conjunction with all other relevant architectural, structural, civil, MEP, and specialist consultant · Fire exits, fire extinguishers, smoke detectors, and other life safety elements must be installed as per the code and authority having
drawings. jurisdiction.
· Any discrepancies between drawings or between drawings and site conditions shall be reported to the architect before proceeding. · Contractor must follow OSHA/local safety regulations during all phases of construction.
· All dimensions are in millimeters (mm) unless otherwise specified. 6. Services and Coordination
· Use figured dimensions only. Do not scale drawings. · Mechanical, electrical, and plumbing services shown on these drawings are indicative. Refer to MEP consultant drawings for details.
· Existing conditions must be verified on-site by the contractor prior to construction. · Contractor is responsible for coordination among all trades to avoid conflicts.
2. Site and Setting Out · Maintain access panels for all services, valves, dampers, junction boxes, etc., as per manufacturer's requirements.
· Contractor to verify existing site levels, boundaries, and all reference benchmarks before commencing work. 7. Finishes and Detailing
· All setting out is to be done from established gridlines and reference points as indicated on site and approved by the architect or · Refer to finish schedule and elevations for final materials, patterns, colors, and textures.
engineer. · All floor transitions between materials must be flush unless otherwise noted.
· Trees, utilities, or structures to remain are to be protected during construction.
· Expansion and control joints must be installed as detailed and in accordance with manufacturer recommendations.
3. Materials and Workmanship
8. Documentation and Approvals
· All materials and workmanship shall comply with current relevant standards (e.g., ISO, ASTM, local building code).
· Shop drawings and samples must be submitted for architect's approval prior to procurement or installation.
· No substitutions of specified materials shall be made without prior approval from the architect.
· All manufacturer installation guides and certificates must be available on-site.
· Contractor shall ensure all finishes are properly matched and applied uniformly.
· As-built drawings and maintenance manuals are to be submitted at project completion.
· All joints between different materials shall be neat, properly detailed, and sealed as required. 9. Temporary Works
4. Structural Coordination · All necessary shoring, bracing, scaffolding, and temporary protection are the responsibility of the contractor.
· Penetrations in structural members must be coordinated with the structural engineer's drawings.
· Maintain protection for existing elements, site access, and occupied spaces.
· Do not drill, cut, or notch any structural member without written approval from the structural engineer.
· Load-bearing elements must not be altered or removed unless shown on the approved drawings and structural details.
5. Fire & Safety
· Fire-rated assemblies (walls, doors, ceilings, etc.) must comply with fire rating requirements specified on the drawings and in the
A GENERAL NOTES
02 SCALE NTS
SIGNED/SEALED: PRC NO. VALIDITY: IMPORTANCE: R.A. 9266 sec. 33 PROJECT TITLE: APPROVED: SHEET CONTENT: REVISIONS: SHEET NO.
PTR NO. TIN NO. A PROPOSED 2 STOREY A
ISSUED AT: DATE SIGNED: RESIDENTIAL BUILDING AS
OWNER SHOWN 06
CIVIL ENGINEER ISSUED ON: ACAD BY: LOCATION: TUGUEGARAO CITY ADDRESS:
