WWW.PHIHONG.
COM
60W 3-in-1 Single Port Media Converter
IEEE802.3bt Compliant Power Injector
Features
• Compliant with IEEE802.3bt/at/af • 4 Pair Powering +3,6,4,5 / - 1,2,7,8
Standard • Non-Vented Case
• 60W POE Power • Limited Power Source
• Extends Ethernet to 200 Meters with • Full Protection OVP, OCP
copper, (can be even more with Fiber) • Single Source 4 Pair Power Current
• Standard SFP Module Input Sharing
• Converts SFP to POE (converts fiber • 1 Year Warranty
to copper)
• Gigabit Compatible
Applications
• IP Telephones • Security Cameras
• Wireless Access Points • IP Print Servers
• Bluetooth® Access Points • WiMAX® Access Points
Safety Approvals
• cUL/UL 60950-1 & 62368-1 • CE
Mechanical Characteristics
• Length: 160mm (6.30in.) • Height: 50mm (1.97in.)
• Width: 180mm (7.09in.) • Weight: 1.7Kg (3.75lbs)
Output Specifications
DC Output Load Regulation1
Model AC Input
Voltage Min. Max.2 Line Load
+56VDC +1V/-2V
POE60S-1BT-R IEC320(C14) 56V <20mA 1.07A
(54-57VDC)
Notes:
1. Voltage measured within 2” of the output RJ45 connector on data pairs 3,6(+) and 1,2(-) at 25ºC
2. Combined output on data pairs and spare pairs. Otherwise 535mA on data pairs 3,6(+) 1, 2(-) and spare pairs 4,5(+)
7,8(-)
Phihong is not responsible for any error, and reserves the right to make changes without notice. Please visit our website at www.phihong.com for
the most up-to-date specifications and contact information.
Revision 8/11/2021
POE60S-1BT-R Characteristics WWW.PHIHONG.COM
INPUT:
AC Input Voltage Range Immunity
90VAC to 264VAC ESD: IEC61000-4-2. Level 3
RS: IEC61000-4-3. Level 3
AC Input Voltage Rating EFT: IEC61000-4-4. Level 3
100 to 240VAC Surge: IEC61000-4-5. Level 3
CS: IEC61000-4-6. Level 3
AC Input Current PFMF: IEC61000-4-8 Level 5
2.0A (RMS) max for 90VAC Voltage Dips IEC61000-4-11
1.0A (RMS) max for 240VAC Harmonic: IEC61000-3-2 Class A
Leakage Current Insulation Resistance
3.5mA max @ 254VAC/50Hz Pri. to Sec.: >10M OHM 500VDC
Pri. to F.G.: >10M OHM 500VDC
AC Inrush Current
40A (RMS) max for 115VAC Dielectric withstand(HI-POT) test
80A (RMS) max for 230VAC Pri. to Sec.: 4242VDC for 1min 10mA
Pri. to F.G.: 2121VDC for 1min, 10mA
OUTPUT:
Total Output Power FEATURES:
60W @40˚C Over Current Protection
1350mA max
Output Ripple
500mV max @25˚C Over Voltage Protection
120VDC max
Efficiency
75% (typical) at max load LED Indicators
Led #1
Hold-up Time Blinking GREEN – Unit is “ON” Active with
16mS min. 120VAC/60Hz max load No Load
Solid GREEN – Unit has detected a Valid
ENVIRONMENTAL: IEEE802.3at/IEEE802.3af Load/IEE802.3bt
Temperature Solid RED – Unit is in Over Load Condition
Operation -10°C to +45°C @60W or Unit has detected an Invalid Load
+45°C to +55°C @30W Led #2
Humidity 5 to 90% Solid GREEN = AC Power Good
EMI Input Connector
FCC Part 15 Class A IEC320 inlet 3 pin(C14)
EN55032/22 Class A
EN50121-4 Output Connection
IEC 62236-4 +pins 3,6,4,5 / -pins 1,2,7,8
Revision 8/11/2021
Dimension Diagram Unit:mm
Revision 8/11/2021
Supplier’s Declaration of Conformity
47 CFR § 2.1077 Compliance Information
Phihong USA Corporation
47800 Fremont Boulevard
Fremont, CA 94538
Telephone: (510) 445-0100
www.phihong.com
NOTE: This model has/The models in this products series have been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to equipment not expressly approved by PHIHONG could void the user’s authority to operate the
equipment.
Revision 8/11/2021
Mouser Electronics
Authorized Distributor
Click to View Pricing, Inventory, Delivery & Lifecycle Information:
Phihong:
POE60S-1BT-R
