WWW.PHIHONG.
COM
30W, IEEE802.3at Single Port PoE Active Injectors
x
Features
• IEEE802.3at Complaint • Three Wire Input Models
• DOE VI Efficiency • Full Over-Voltage and Over-Current
• EU CoC Version 5 Tier 2 Efficiency Protection
• Compact Size • Non-Vented Case
• Limited Power Source • 1 Year Warranty
Applications
• IP Telephones • Security Cameras
• Wireless Access Points • IP Print Servers
• Bluetooth® Access Points • WiMAX® Access Points
Safety Approvals
• cUL/UL (62368-1) • CE
• CB (IEC62368-1) • UL,cUL, CB 60950-X
Mechanical Characteristics
• Length: 140.1mm (5.52in.) • Height: 30.0mm (1.18in.)
• Width: 45.5mm (1.79in.) • Weight: 200g (7.04oz)
Output Specifications
DC Output Load Regulation1
Model Data Speed
Voltage Min. Max. Line Load
POEA30U-1AT-R2 1G 56V 10mA 536mA 54-57V
POEA30U-1ATE-R 1G 56V 10mA 536mA 54-57V
POEA30U-1AT-2-R 2.5G 56V 10mA 536mA 54-57V
POEA30U-1AT-5-R 5G 56V 10mA 536mA 54-57V
POEA30U-1AT-X-R 10G 56V 10mA 536mA 54-57V
Notes:
1. Voltage measured within 2” of the output RJ45 connector on data pairs 3,6(+) and 1,2(-)
2. Unshielded RJ45 jacks
Phihong is not responsible for any error, and reserves the right to make changes without notice. Please visit our website at www.phihong.com for
the most up-to-date specifications and contact information.
Revision 1/11/2019
POEA30U-1AT-R Characteristics WWW.PHIHONG.COM
INPUT: Isolation (HI-POT)
AC Input Voltage Range 4242VDC for 1 minute, 10mA
90 to 264VAC
Insulation Resistance
AC Input Current Primary to secondary:>10M Ohm 500VDC
0.8A (RMS) max
FEATURES:
AC Input Frequency Over Voltage Protection
47Hz to 63Hz Non-Latching auto recovery
Leakage Current Over Current Protection
3.5mA max @254V, 50Hz <750mA Non-latch
Max In-rush Current Short Circuit Protection
60A max at 240VAC and max load Non-Latching auto recovery. Output can be
(Cold Start at ambient 25°C) shorted permanently without damage.
OUTPUT: LED Indicators
Output Power Green LED Slow Blinking – No connection
30W, de-rated up to 15W at 50°C Green LED Fast Blinking – No Load
Green Solid – Power Good
Hold up Time Green/Yellow Fast Blink – Fault Detected
10mSec min at max load at 120VAC, 60Hz Yellow Solid with Green Blink – Over/Short
Current Detected
Efficiency
Minimum 85% @max load AC Input Connector
IEC320 C14 -
ENVIRONMENTAL
Temperature Output Connection
Operating -10°C to +40°C 56VDC RJ45 Pins 3&6
Non-operating -20°C to +70°C 56VRTN RJ45 Pins 1&2
Relative Humidity 5 to 90%
EMI
EN55032 Class B, FCC part 15 Class B
EMC
ESD: IEC61000-4-2 , Level 3
RS: IEC61000-4-3, Level 3
EFT/Burst: IEC61000-4-4, Level 2
Surge: IEC61000-4-5, Level 3
CS: IEC61000-4-6 , Level 3
Voltage Dips: IEC61000-4-11, Class 3
Harmonic: IEC61000-3-2, Class A
Revision 1/11/2019
Dimensional Diagram Unit: mm WWW.PHIHONG.COM
Revision 1/11/2019
Supplier’s Declaration of Conformity
47 CFR § 2.1077 Compliance Information
Phihong USA Corporation
47800 Fremont Boulevard
Fremont, CA 94538
Telephone: (510) 445-0100
www.phihong.com
NOTE: This model has/The models in this products series have been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to equipment not expressly approved by PHIHONG could void the user’s authority to
operate the equipment.
Revision 1/11/2019
