Corsa Error Codes
Uploaded by
ScribdTranslationsCorsa Error Codes
Uploaded by
ScribdTranslations#7· ▲
RE: Workshop manual Corsa B
Well, I found them already. Whoever needs them, here I leave them:
The MIL lamp on the dashboard lights up when the vehicle is in contact, but when starting it,
it must be turned off. If it stays on or lights up while the vehicle is in motion, this indicates
that the ECU has detected a fault
To access the error codes, if any, pins A and B must be shorted together.
in the diagnostic connector, the codes will appear on the dashboard lamp as flashes that
it will be necessary to count to know the number. For example, error code 12 will be: Flash pause Flash
Flash
To clear the memory error code, disconnect the negative from the battery for a while.
less than a minute.
Code
Component that causes it
12 Start of diagnosis
13 Lambda Sensor (Open Circuit)
14 Coolant Temperature Sensor (Low Voltage)
15 Coolant Temperature Sensor (High Voltage)
16 Knock Signal
18 Active Punch Control System
19 Incorrect RPM signal
21 Throttle Position Sensor (High Voltage)
22 Throttle Position Sensor (Low Voltage)
24 Speed Sensor (No Signal)
25 Injector (Low Voltage)
29 Fuel Pump Relay (Low Voltage)
32 Fuel Pump Relay (High Voltage)
33 Sensor Map (High Voltage)
34 Sensor Map (Low Voltage)
35 Stepper Motor (No Idle Control)
41 EST Bobina Cylinders 2 & 3 (High Voltage)
42 EST Bobina Cylinders 1 & 4 (High Voltage)
43 EGR System
44 Lambda Sensor (Very Lean Mixture)
45 Lambda Sensor (Very Rich Mixture)
47 Position of the EGR System
49 High Battery Voltage
51 E.C.U. (Memory Failure)
55 E.C.U.
63 EST Coil Cylinders 2 & 3 (Low Voltage)
64 EST Coil Cylinders 1 & 4 (Low Voltage)
75 Torque Control (Low Voltage)
76 Torque Control (Continuous)
81 Injector (High Voltage)
93 Command Module Coils