We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
You are on page 1/ 1
INSTALLATION AND
OPERATING INSTRUCTIONS
IMPORTANT
+ This devices tobe Installed and operated by skied and qualified
personnel ONLY and in compliance with current standards to avait
‘damage and safety hazards.
+ Foruse within specifies parameters ony
+ Ensure adequate ar-fow ove al sides of case.
+ Donotinstalin posit of exploshe gases o ameatie materia.
+ solate the AC input supply and battery before any conection ot
INSTALLATION
‘The charger should only be installed ia electrical panes with covers
‘0% doors and adequate vetiation shoul be considered
‘Mount the unit ona fat heat conductive surface
‘The charger can be mounted on symmetrical 3 «7 Sm ON rail
fied using 2 No. (lagonally or 4 No. Ma screws through the
preformed holes in the mounting anges
Leave at last 1Smm of space on allies for adequate heat
‘persion and free a convection
CONNECTION
Ensure that the AC supply and batter ate iklated Before connection
tie good practice total he charger cose tothe battery and to
use conductors of sufcentcote-sction to minimise voltage drops
{thus maslmising the battery charge)
‘The AC input shouldbe protected by an MCB or fuse
‘A1OAHRC DC output fuse shoul be ited fr battery protection
OPERATION
Default Mode (2 Stage Charger With Battery Detection):
‘The MAS 06121 designed for charging most battery types
‘The default configurations 3 stage (ul absorb / ot)
When 2 bateryis connected the chargers output switches. to
charge the battery
Removalof the battery and ll connectes lad switches the output off
‘The ehrger i protected agaist reverse Datery polarity ln this made.
PSU Mode (PSU 2 Stage Charger Without Battery Detection)
king pins 72nd 8 ofthe signa connector‘ forces the charger
‘nto PSU mode (constant current / constant vatage output) where
the chargers outputs alnayson
‘The charger sna protected agaist reverse battery payin this rede
OUTPUT VOLTAGE CALIBRATION
“The output at voltage i factory preset 13 BV (WV wits) 01276
(24V unt. The operator MUST ensure that the chargers autput ot age
‘ssetin accordance with the battery manufactures recommendations.
Toset the output voltage:
+ Discanrect the battery ard alloads connected tothe outa terminas
«attach calrated DVM tothe +/- output terminals,
+ Turn the ‘CAL pot fully anti-cockaise (minim). The LED of.
+ When the LED ashes Geen / Red adust the 'CAL'pot tothe
‘ested output voltage, displayed onthe OVMA
+ When the LED stops Mashing Green / Red the units arated,
STATUS LED MODES
yoy)
rt Ft
foe ta
thane San
a Cee ae
Pra
DTT Tay
arge
Prereree very
PrCreceste!
a
—_ Inputeurent —-1SAmax
DC OUTPUT votage Garren RVEoApE (RV mode)
RATING 2430p (24V mel)
ple noe «OSH
Unereguation 10%
Loadreguation 1.0%
rhclency——_Upt090%
OPERATING — Oreatngtenperatue Wro.s0%
CONDITIONS Sotengesture 2040-8540
CONNECTION Rising camp emirate
Nour cate cos-sectio 2S?
ENCLOSURE "ghinpact As pst, bac fash
WEIGHT “00game
EXTERNAL CONNECTIONS & DIMENSIONS
row evanen
——™——4
worw.meccalte.com
POWER FROM WITHIN
