HI,
I am using sway 1.0. My monitor's default resolution is 2560x1440. I force the TTY resolution to 1920x1080 by using kernel parameter like "video=HDMI-A-1:1920x1080" as recommended in sway Archwiki . Thus I am able to set the new resolution in sway's config. Command `swaymsg -t outputs' shows the current mode is 1920x1080 and there are 2 modes available.
When I run the waybar, I ended up with width of 2560. Not the width of my current resolution that I set. Thus some part of the bar is not visible.
Waybar output is like:
Bar width configured: 1920
Bar width configured: 2560
New height: 30
New height: 30
Can I get around this?
Thanks.
HI,
I am using sway 1.0. My monitor's default resolution is 2560x1440. I force the TTY resolution to 1920x1080 by using kernel parameter like "video=HDMI-A-1:1920x1080" as recommended in sway Archwiki . Thus I am able to set the new resolution in sway's config. Command `swaymsg -t outputs' shows the current mode is 1920x1080 and there are 2 modes available.
When I run the waybar, I ended up with width of 2560. Not the width of my current resolution that I set. Thus some part of the bar is not visible.
Waybar output is like:
Bar width configured: 1920
Bar width configured: 2560
New height: 30
New height: 30
Can I get around this?
Thanks.