With this you are able to clone your RFID Card or Tag
please support this repository with STAR
Checkout Stable Release Versions
- Official CH340 Driver Download Here (ONLY FOR Arduino CLONE)
- Arduino Nano
- Oled Display 0.96 Inch
- RC522 RFID Module
- 2 Buttons
- 2x Resistor with 220 Ohm (for buttons !)
- Bread Board
- Some Wires (about 20pcs)
- Arduino SD Card Module (Used only for DonkRFID-OledV3-SaveToSD-Card.ino)
- 2x LED Diodes (RED and GREEN) and 2x 220 Ohm resistor (if u use LEDs)
- Just added for show status (RED lights up if emulating or reading failed and green for opposite)
| Modul / Funkcia | Signál / Popis | Pin Arduino Nano |
|---|---|---|
| MFRC522 (SPI) | SDA (SS) | D10 |
| SCK | D13 (SPI SCK) | |
| MOSI | D11 (SPI MOSI) | |
| MISO | D12 (SPI MISO) | |
| RST | D9 | |
| VCC | 3.3V | |
| GND | GND | |
| SD Karta (SPI) | CS | D4 |
| SCK | D13 (zdieľané) | |
| MOSI | D11 (zdieľané) | |
| MISO | D12 (zdieľané) | |
| VCC | 5V | |
| GND | GND | |
| OLED I2C | SDA | A4 |
| SCL | A5 | |
| VCC | 3.3V / 5V | |
| GND | GND | |
| RDM6300 (125 kHz) | TX (výstup z modulu) | D6 (RX Arduino) |
| VCC | 5V | |
| GND | GND |
- Will be added 125 KHz support
- Auto Detect Mode
- Auto Saving data separately to SD Card
- if you have any problems, doublecheck you wiring & functional modules like RFID reader, display, etc...
- Make sure you have installed drivers (arduino clones must have driver CH340) Download Here