@ @ @@@@@ @ @@@@@@@@@@
@@@ @@@ @@@@@@@@@@@@@ @@@ @@@@@@@@@@
@@@@@@ @@@@@@ @@@@@@@@@@@@@@@@@ @@@@@@ @@@@@@@@@@
@@@@@@@@ @@@@@@@@ @@@@@@@@@@@@@@@@@@@@@@@@@@@ @@@@@@@@@@
@@@@@@@@@@@@@@@@@@@@@ @@@ @@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@
@@@@@@@@@@@@@@@@@@@@@@X@@@@@@@@@ @@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@
@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@ @@@@@@@@@@@@@@@@@ @@@@@@@@@@@@@@@@@@@@
@@@@@@@@@@@@@@@@@@@@@@@@@@@X@@@@@@@@@ @@@@@@@@@@@@@ @@@@@@@@@@@@@@@@@@@@
@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@ @@@ @@@@@ @@@@@@@@@@@@@@@@@@@@
@@@@@@ @@@@@@@@@@@@@@@@@@@@ @@@@@@@@@@@@@@@@@@@@
@@@@@@@@@@@@@ @@@@@@@@@@@@@@@@@@@@ @@@@@@@@@@@@@@@@@@@@
@@@@@@@@@@@@@@@@@ @@@@@@@@@@@@@@@@@@@@ @@@ @@@@@@@@@@@@@@@@@@@@
@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@ @@@@@@@@@@@@@@@@@@@@@@@@@@@@@
@@@@@@@@@@@@@@@@@@@@@ @@@@@@@@@@@@@@@@@@@@@@@@@@@@@@ @@@@@@@@@@
@@@@@@@@@@@@@@@@@@@ @@@@@@@@@@@@@@@@@@@@ @@@@@@@@@ @@@@@@@@@@
@@@@@@@@@@@@@@@ @@@@@@@@@@@@@@@@@@@@ @@@ @@@@@@@@@@
@@@@@@@@ @@@@@@@@@@@@@@@@@@@@ @@@@@@@@@@
A Teensy powered DSP module for Teenage Engineering OP-Z housed in a custom LEGO enclosure with swappable panels. Based on forked OP-Z Teensy code with ongoing hardware and firmware refinements.
- Hardware
- v2 LEGO Enclosure: Work-in-Progress
- USB-C > MIDI: Working
- Audio Adaptor: Soldering
- 3.5mm Breakout Board: Soldering
- USB-C Breakout Board: Soldering
- Software
- DSP Code: Working
- Added Expressive LED
Use Arduino IDE to open opz-teensy and configure with Tools > USB Type > MIDI then upload to a Teensy board with an Audio Adaptor Shield.
- Teensy 4.0 or Teensy 4.1
- Teensy Audio Adaptor Rev D
- TRSS 3.5mm Jack Breakout Board
- USB-C Breakout Board - Horizontal
- 2x Straight Header - Male 14-Pin
- Teensy Extended Header Kit
- Green Dial → Reverb Mix
- Blue Dial → Delay Time
- Yellow Dial → Drive Amount
- Red Dial → Filter Cutoff
- Track 1 CC (Kick) → Input Level
- Track 2 CC (Snare) → Bitcrusher