Search results

Problem: Unable to setup FluidNC /communicate with Queenbee xPRO V5

Status: Open.

#1629 In bdring/FluidNC;

· alphonse1475-prog opened on Dec 17, 2025

Problem: Job crashes upon Wifi disconnect

Status: Open.

#1628 In bdring/FluidNC;

· f1adang opened on Dec 16, 2025

Problem: Modbus RS485 frame misalignment

Status: Open.

#1620 In bdring/FluidNC;

· ajmirsky opened on Dec 2, 2025

Problem: v4.0.0-pre2 WIFI mode AP ESP32 WEBUI3 timeouts

Status: Open.

#1618 In bdring/FluidNC;

· PhiJu5 opened on Nov 30, 2025

Problem: Spindel spinup_ms doesn't work

Status: Open.

#1617 In bdring/FluidNC;

· 20Jakob09 opened on Nov 29, 2025

Problem: Fluid Dial interferes with FluidNC when it runs gcode

Status: Open.

#1615 In bdring/FluidNC;

· eug3nix opened on Nov 24, 2025

Problem: Bad Defaluts for /uart?/passthrough_mode

Status: Open.

#1614 In bdring/FluidNC;

· dnikodem84 opened on Nov 24, 2025

Problem: The laser engraving grayscale card of the COREXY structure is experiencing lag.

Status: Open.

#1596 In bdring/FluidNC;

· junzilang383 opened on Oct 25, 2025

Problem: BUG Fix FluidNC/src/Kinematics/ParallelDelta.cpp Line 291 should read return false; instead of just false;.

Status: Open.

#1593 In bdring/FluidNC;

· TmanEdi opened on Oct 12, 2025

Problem: Expander pin configuration failed

Status: Open.

#1592 In bdring/FluidNC;

· DmiZar opened on Oct 11, 2025

Problem: Web Installer detects wrong stepping engine in UI compared to yaml config

Status: Open.

#1588 In bdring/FluidNC;

· Kleebz opened on Oct 7, 2025

Problem: GCode error with DragKnife

Status: Open.

#1573 In bdring/FluidNC;

· heiserhorn opened on Sep 24, 2025