This projects creates a Homekit bridge and accessories for the Intelbras AMT8000 alarm system.
This project is set up using environment variables.
Full list of them and what they are for:
# Alarm IP addr.
# required.
HOST=192.168.207.4
# Alarm password.
# Should be the remote configuration password (usually 6 digits).
# required.
PASSWORD=123456
# Cental port.
# default: 9009.
PORT=9009
# Zones that are motion sensors.
MOTION="1,2,3"
# Zones that are contact sensors (i.e. doors, windows).
CONTACT="4,5,6"
# Zones to show the bypass switch for.
BYPASS='1,2,3,4,5,6,7,8'
# Indexed zone names.
# default: "Zone 1,Zone 2,..."
ZONE_NAMES="Kitchen door,Living Room Window"
# Partitions to arm when set stay mode.
# required.
STAY="1,2"
# Partitions to arm when set to night mode.
# required.
NIGHT="2,3"
# Partitions to arm when set to away mode.
# required.
AWAY="0"
# Siren numbers you want to be shown.
# It'll show them as a contact sensor, with Tamper and Battery status.
SIRENS="1,2"
# Repeater numbers you want to be shown.
# It'll show them as a contact sensor, with Tamper and Battery status.
REPEATERS="1,2"
# If the alarm is triggered, and you turn it off, after this amount of time the
# bridge will automatically clean the firings.
# If empty or 0, it will not automatically do that.
CLEAN_FIRINGS_AFTER=5mWarning
the away mode of the Homekit bridge does not translate to the per-manual stay mode in the Intelbras alarm system, mainly because it is supper confusing. Instead, the alarm system here has 4 states:
- Off
- Night: arms the
$NIGHTpartitions - Away arms the
$AWAYpartitions - Home arms the
$STAYpartitions
Rationale for what to do in each of them can be found here, but basically you'll want to arm all partitions on away, and a subset of partitions on night and stay, depending on your use case.
For me, I created 3 partitions:
- Inside motion sensors
- Outside motion sensors
- Access sensors and doors
And I set it up like so:
AWAY=0
STAY=2
NIGHT=2,3But, you do you. 😄
source .env
go run .Open the Home app, add new accessory, the security system should show up.
Setup code is 001 02 003.
- panic switch
- bypass zones (?)
- multiple partitions per state
- show zones firing
- show partitions firing
- battery statuses
- read alarm mac addr
- receive notifications from the alarm system
The "Intelbras Documentation Sucks" License.
Caution
Be mindful of the license. Go, read it.
No.
No.
No.
No.
Unlikely.
Not in the slightest.