• Compatible with Bambu Studio, better management of the prime tower (3MF)
• Compatible with Orca slicer (3MF)
• Purge sequences fully controlled by the slicer (same behavior as Bambu Lab printers)
• Accurate time and material usage estimates
• 24 mm retraction before filament cut on every color change (saves ~7 meters of filament across 300 color changes)
• Reduced purge multiplier (≈ 0.7) possible without color mixing in most prints
• Flush into object infill flush into object supports and flush into object effectively reduce filament waste
• Material-to-waste ratio rarely exceeds 50%, even on 4-color prints (0.2mm layer height, weight print > 70g)
• Mainsail displays true colors directly from the slicer
• 45 seconds color change time
• Bed leveling before print (Level On/Off)
• External spool printing (IFS On/Off)
• Backup printing mode – up to 4 kg of uninterrupted printing (Backup On/Off)
• Automatic fallback when IFS runs out: the remaining filament in the printhead is used until the next color change
• Filament state detection at print_start to identify the active filament in the extruder
• Detection of jams, breaks and filament runout
• Improved routine for automatic print recovery after power outages or errors

• Install zmod following the instructions
• Change the native display to Guppyscreen running the DISPLAY_OFF command
• Change web ui to Mainsail running the WEB command
• Run ENABLE_PLUGIN name=bambufy command from the console.
• Use this 3MF with Bambu Studio (from there you can save settings such as user profiles)
• Use this 3MF with Orca slicer.

• Run the DISABLE_PLUGIN name=bambufy command from the console.
• (Optional) Go back to stock screen DISPLAY_ON
• (Optional) Go back to Fluidd WEB

Let's do what Flashforge didn't want to do!

Sergei (ghzserg) zmod