The sender and receiver share a secret key, which is used by chacha8 to hash the same input into identical pseudo-random numbers. These pseudo-random numbers are used in obfuscation.

• The first 16 bytes of WG message is obfuscated.
• The mac2 field is also obfuscated, if it is all zeros.
• Padding WG message with random long random bytes.
• Drop keepalive message with 80% probability.
• Change the Diffserv field to zero.

Chacha8 is used here since the goal is not encryption.

Tested working on Alpine linux kernel 5.15 and CentOS 7 kernel 3.10.

• Alpine: alpine-sdk, iptables-dev, linux-lts-dev or linux-virt-dev
• CentOS 7: iptables-devel, kernel-devel
• Debian 10/11 : linux-headers, autoconf, libtool, libxtables-dev, pkg-config

Build:

./autogen.sh
./configure
make

Install:

sudo make install

One may need run depmod -a && modprobe xt_WGOBFS to load the kernel module.

This extension takes two parameters.

--key for a shared secret between client and server. If a key is a long string, it will be cut at 32 characters; if a key is short, then it will be repeated until reaches 32 characters. This 32 characters long string is the key used by chacha8 hash.

--obfs or --unobfs to indicate the operation mode.

Before bring up wg, on client, insert two iptables rules:

iptables -t mangle -I INPUT -p udp -m udp --sport 6789 -j WGOBFS --key mysecretkey --unobfs
iptables -t mangle -I OUTPUT -p udp -m udp --dport 6789 -j WGOBFS --key mysecretkey --obfs

The above rules assuming remote server is listening on port 6789. On server, do the opposite:

iptables -t mangle -I INPUT -p udp -m udp --dport 6789 -j WGOBFS --key mysecretkey --unobfs
iptables -t mangle -I OUTPUT -p udp -m udp --sport 6789 -j WGOBFS --key mysecretkey --obfs

Mangle FORWARD chain shall also work.

It is necessary to clamp TCP MSS on TCP traffic over tunnel. Symptoms of TCP MSS problems including HTTP not working on some websites, ssh works but scp doesn’t work.

iptables -t mangle -A FORWARD -p tcp --tcp-flags SYN,RST SYN -j TCPMSS --clamp-mss-to-pmtu

Test in two Alpine linux VMs on same host. Each VM has 1 CPU and 256M RAM. Iperf3 over wg reports 1.1Gbits/sec without obfuscation, 950Mbits/sec with obfuscation.

See openwrt/package/README.md

GPL v2