Salt formula to setup and configure Consul.

Not production ready (out of the box). Close, but not there just yet. To get it working will require a bit of fiddling until I get a chance to test this 100%. Sorry, just mad busy right now...

The Consul agent will usually be run on every host in your environment, so your top.sls file may look something like this:

base:
  '*':
    - consul

You may optionally set the desired datacenter from a pillar or a grain. By default consul.io will put the nodes in DC1.

To specify a datacenter for a group of nodes, add the datacenter field to the consul object in Pillar:

consul:
  datacenter: 'datacenter6'

You may also set a specifc node to a datacenter via a grain:

salt <node> grains.setval datacenter dev

which will populate /etc/salt/grains with the key of datacenter and value of "dev"

To delete the grain

salt <node> grains.delval datacenter destructive=True 

To specify which nodes will behave as Consul servers, add the server_target field to the consul object in Pillar. Which, by default, accepts a Glob match of servers:

consul:
  server_target: 'consul-server*'

The same applies to the minions that should serve the Consul UI, the field ui_target specifies the Web UI target:

consul:
  # ..
  ui_target: 'consul-web01'

Setting this will bring up the UI bound to localhost and available via a SSH tunnel. The default install directory is /opt/consul/ui.

If you wish to make a minion a public facing UI (ie bind's to eth0 and not localhost) then set ui_public_target:

consul:
  # ..
  ui_target: 'consul-web01'
  ui_public_target: 'consul-web01'

and UI will be available on http://consul-web01:8500/ui

You may also set a specifc node to a ui_target via a grain:

salt <node> grains.setval consul_ui_target True

which will populate /etc/salt/grains with the key of consul_ui_target and value of "True"

To delete the grain

salt <node> grains.delval consul_ui_target destructive=True 

You may also set a specifc node to a server via a grain:

salt <node> grains.setval consul_server_target True

which will populate /etc/salt/grains with the key of consul_server_target and value of "True"

To delete the grain

salt <node> grains.delval consul_server_target destructive=True 

If you would prefer to do a compound or grain match or some other match type, you can add the targeting_method field to Pillar:

consul:
  # ..
  server_target: 'consul:server'
  targeting_method: 'grain'

Because Bootstraping is a one off task and should only be run on the first node in the cluster, you can perform a Bootstrap on one node by manually pass in a consul_bootstrap Pillar arg using state.sls.

salt 'consul-server01' state.sls consul pillar={'consul_bootstrap': true}

Note: do not set consul_boostrap to true in your Pillar files!

Then, you should deploy you other server nodes as per the Joining servers section.

Servers are automatically joined to the cluster if more than 1 server node is discovered in the server_target match. However, for this to work, you'll need to setup the Salt Mine on each minion by editing /etc/salt/minion.d/mine_functions.conf and adding these lines:

mine_functions:
  network.get_hostname: []
  grains.items: []

Then, you can add servers like so:

salt 'consul-server0[2-5]' state.sls consul

Once the datacentre is bootstraped and you have more than 1 node, you can reapply the Salt state the first, bootstrapped node without setting the consul_bootstrap Pillar, to take it out of bootstrap mode.

salt 'consul-server01' state.sls consul