Blynk flow sensor water meter to measure water consumption using Blynk, NodeMCU and Water Flow Sensor (I used YF-S201B).

This repository focuses on the IDEA LAB for 1st and 2nd semester students using SST-IoT-Board. Feel free to open PR's

This repository is my personal collection of all legacy server binaries released by Blynk

Blynk and WiFiManager Library for configuring/auto(re)connecting ESP8266/ESP32 modules to the best or available MultiWiFi APs and MultiBlynk servers at runtime, with or without SSL. Configuration data saved in either SPIFFS or EEPROM.

Simple WiFiManager for Blynk and ESP8266/ESP32 (including ESP32-S2, ESP32-C3) with or without SSL, configuration data saved in either LittleFS, SPIFFS or EEPROM. This library, using AsyncWebServer instead of (ESP8266)WebServer, for configuring/auto(re)connecting ESP8266/ESP32 modules to best or available MultiWiFi APs and MultiBlynk servers at r…

Платформа с приложением для iOS и Android для управления Arduino, ESP8266, Raspberry Pi и других плат микроконтроллеров через Интернет.

A project that logs data from sofar solar inverter and sends the data to blynk server using RS485 modbus interface.

Here are the Programs that can be done on a SST IoT Node MCU ESP8266 Board.

Tools for working with Blynk IoT Platform

This repository focuses on Programs that can be achieved using SST IoT Development Board which is an ESP32 Development Kit

Enable inclusion of both ESP32 Blynk BT / BLE and WiFi libraries. Then run both WiFi and BT/BLE simultaneously, or select one to use at runtime after reboot. Eliminate hardcoding your Wifi and Blynk credentials and configuration data saved in either SPIFFS or EEPROM.

Blynk PZEM 004T 3 Phase failure motor automation.

Blynk ESP8266 (NodeMCU) Program for PZEM 004T v3.0 Power Meter.

Simple GSM shield Manager for Blynk and ESP32 / ESP8266 boards, with or without SSL, configuration data saved in SPIFFS / EEPROM. This library enables user to include both Blynk GSM/GPRS and WiFi libraries in one sketch, run both WiFi and GSM/GPRS simultaneously, or select one to use at runtime after reboot.

💡 This project proposes an IoT based fall detection and rescue system. The main objective here is to alert the user as well as a guardian/ doctor if there is a possibility of fall.

Controlling the lights in your house using your voice is a great way to dip your toes into the smart homeworld. And if you already have a smartphone you can build your own smart switch using a few bucks.

Thiết bị theo dõi chỉ số cơ thể sử dụng ESP32 và cảm biến MAX30102 để đo nhịp tim và SpO₂. Dữ liệu được hiển thị trên màn hình OLED SSD1306 và gửi lên Blynk để theo dõi từ xa. Hệ thống có thể ứng dụng trong giám sát sức khỏe cá nhân.

Local Blynk Server Using the Arduino connected via Serial/USB