Driver for the range of RFM95(W) (LoRA) RF transceiver modules using STM32Cube HAL

STM32 and AVR128 Printed Circuit Board for creating IOT nodes with the RFM95 LORA chip

An example LoRaWAN Application on the Zephyr RTOS

The SparkFun Pro RF is a LoRa®-enabled wireless board that marries a SAMD21 and a long-range RFM95W to make a compact and easy-to-use IoT Arduino board.

A tinygo library to run RFM9X LoRa radio modules - RFM95/96/97/98 (W)

LoRa and WiFi based IoT agricultural monitoring system: transmitter side

Remote Sensor Project

Ultra low cost LoRaWAN temp & humidity sensor based on Atmega328p , DHT 11 and RFM95W LoRa WAN module

LoRa and WiFi based IoT agricultural monitoring system: receiver side

LoRa node for reading the status of a connected contact using the Arduino Pro Mini on a Li-Ion cell

LoRa node for measuring the pool water and air temperature using the Arduino Pro Mini on a Li-Ion cell

A breadboard friendly breakout board for the RFM95 LoRa module.

Arduino with RFM69 ISM radio running at 1.8V

Send ADC voltage and other payload via LoRa RFM95W

LoRa node for measuring the temperature using the Arduino Pro Mini on a Li-Ion cell

ATTiny1614 + SX1276 + BME280

LoRa node for reading the pulses of the energy meter using the Arduino Pro Mini on a Li-Ion cell

DIY lora gateway using Wemos D1 ESP8266

LoRa Weather for my weather station using the Arduino Pro Mini on a Li-Ion cell