Print-Toyota Service Information 11/3/17, 6(41 pm
Print Exit
1GD-FTV LUBRICATION OIL LEVEL SENSOR INSPECTION
PROCEDURE
1.INSPECT ENGINE OIL LEVEL SENSOR 89491
a.
Component without harness connected
*a
(Engine Oil Level Sensor)
*b On
*c Off
Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Switch Specified
Connection Condition Condition
On at below
Below 1 Ω
40°C
Off at below
Below 1 Ω
40°C
1-2
On at 60°C or
Below 1 Ω
higher
Off at 60°C or 10 kΩ or
higher higher
CAUTION:
· Do not put your hands in the water warmed up during the inspection.
· Touching the hot water may result in burns.
NOTICE:
When checking the engine oil level sensor in water, do not allow water to contact the terminals. After
completing the check, dry the engine oil level sensor.
HINT:
· In addition to a level switch, the oil level sensor also has a temperature switch. Therefore, make
https://toyotamanuals.com.au/docs/hilux-service-repair-manual-…manual/repair/contents/RM100000000M7SS.html?PUB_TYPE=RM&MODE=1 Page 1 of 2
Print-Toyota Service Information 11/3/17, 6(41 pm
sure to check the oil level sensor at both high and low temperatures.
· If the result is not as specified, replace the engine oil level sensor.
© 2012 TOYOTA MOTOR CORPORATION. All Rights Reserved.
https://toyotamanuals.com.au/docs/hilux-service-repair-manual-…manual/repair/contents/RM100000000M7SS.html?PUB_TYPE=RM&MODE=1 Page 2 of 2