Print-Toyota Service Information 11/3/17, 5(37 pm
Print Exit
1GD-FTV ENGINE CONTROL INTAKE AIR TEMPERATURE SENSOR INSPECTION
PROCEDURE
1.INSPECT INTAKE AIR TEMPERATURE SENSOR 89424D
a. Partially immerse the intake air temperature sensor in water and warm up the water.
b. Measure the resistance according to the value(s) in the table below.
Component without harness connected
*a *b Resistance
(Intake Air Temperature Sensor)
*c Temperature *d Acceptable Range
Standard Resistance:
Tester Specified
Condition
Connection Condition
2.21 to 2.65
20°C (68°F)
kΩ
1-2
0.54 to 0.62
60°C (140°F)
kΩ
CAUTION:
· Do not put your hands in the water warmed up during the inspection.
· Touching the hot water may result in burns.
NOTICE:
When checking the intake air temperature sensor in water, do not allow water to contact the terminals.
After completing the check, dry the intake air temperature sensor.
If the result is not as specified, replace the intake air temperature sensor.
© 2012 TOYOTA MOTOR CORPORATION. All Rights Reserved.
https://toyotamanuals.com.au/docs/hilux-service-repair-manual-…manual/repair/contents/RM100000000MHUV.html?PUB_TYPE=RM&MODE=1 Page 1 of 1