0% found this document useful (0 votes)
42 views3 pages

Man CP-Valves en

Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
42 views3 pages

Man CP-Valves en

Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

English C Ensure the valve arrows face in the direction of

water flow, and push valve onto inlet and outlet


pipes until secure. Follow PVC cement instruc-

Rain+Birdt
tions for cure time.

CP/CPF Series Valve Installation


and Operation
1 2
SOLENOID

FLOW CONTROL
(select models) TO LANDSCAPE WATER SOURCE

BLEED
SCREW
Connect Valve Wires

bb
NOTE: Use watertight connectors and direct
OUTLET burial wire for all connections.

A Connect one solenoid wire to a common wire


(usually white). All valves can share the same
INLET common wire.

B Connect the second solenoid wire to a power


wire (usually colored).

BODY

Before Installation
llInstall master valves, pressure regulators and back-
flow preventers as needed.
llA pressure regulator is required if water pressure
1
exceeds 150 PSI (recommended over 80 PSI).
llInline valves require a separate backflow preventer
in the main line. Check local building codes. 2
llFlush the system thoroughly until water runs clear.

llShut off the main water supply.

Connect Valve to Pipes


A Apply PTFE thread-seal tape to the male threads
on the adapters, screw into the valve and
hand-tighten (do not use PVC glue or pipe dope
on adapter threads).

B Apply primer and then PVC cement to the ends


of the pipe and inside the adapters per manu-
facturer’s instructions.
1
Valve Operation Operating Ranges
075-CP / 075-CPF 100-CP / 100-CPF
Manual Operation:
Flow2 0.2 - 22 GPM 0.2 - 40 GPM
A Manual on: Turn the solenoid counter-clockwise Pressure 15 - 150 PSI 15 - 150 PSI
1/4 turn. Do not unscrew completely. To close,
hand tighten clockwise.
bb
NOTE: For flows below 3 GPM (0.75 m3/h), or
any drip application, use a 200 mesh filter up-
B Flow control (select models only): Turn clock-
stream and a pressure regulating filter down-
wise to restrict flow. Turn counter-clockwise to
stream from the valve. 40 psi for 1” and 30 psi for
open flow.
3/4” drip lines.
C Flush valve to clear debris: Turn the bleed screw
Troubleshooting
counter-clockwise ONLY 1 turn. Flush one min-
ute and turn clockwise to close. Symptom Solution
Valve Make sure flow control is open (select
First Use:
Won’t Turn models)
D Open the main water supply and flush one min- On when
Solenoid is
Check that main water supply is on
Make sure piping is connected properly and
ute with bleed screw to clear debris.
Turned not blocked
E Test wiring by using the Manual Water feature Verify timer settings are correct
on the irrigation controller. Check and repair wiring and connections as
Valve Won’t
needed
F Adjust the flow control to reduce over-spray. Turn On at
Check and replace valve solenoid as need-
(select models). the Timer
ed
Verify timer power output
Verify timer settings are correct
Valve Won’t
Hand tighten solenoid and bleed screw if
Shut-off
needed
Incorrect timer settings
2 Check wiring
Valve Won’t
Check solenoid
Turn On at
the Valve Timer not supplying power to the valve
1 Make sure the Flow Control stem is not
turned all the way closed
Clear debris by opening the bleed screw
Leaks at
and flushing 1 minute
sprinkler
Remove and clean the diaphragm. Replace
heads
3 if needed.
Check pipe fittings connection and glue,
repair or replace as needed
Hand tighten solenoid and bleed screw if
needed
Pressure Loss Chart Leaks around If vacuum breaker is leaking (anti-siphon
the valve models) remove cap, gasket, and internal
12
piston gasket to clean and reassemble
Pressure Loss - PSI

10 Turn off main water supply, relieve pressure


on the valve by opening the bleed screw
8
and tighten the jar top bonnet
6

bb
NOTE: During winter, shutdown and drain the
4
system to protect valves from freezing. Failure to
2 properly drain the lines can result in damage to
0 the valves, which is not covered under the cus-
0 10 20 30 40 50 tomer satisfaction policy.
3/4" CP-075 1" CP-100
Flow Rate - GPM
2
Rain+Birdt
Rain Bird Corporation
Consumer Products Division
6991 East Southpoint Rd. Bldg #1
Tucson, AZ 85756
Tel.: 1-800-RAINBIRD (800-724-6247)
www.rainbird.com

Questions?
In the USA or Canada, call Rain Bird
toll free Technical Support at
1-800-724-6247
or visit our valves support web site

Copyright 2016 Rain Bird Corporation


Registered trademark of Rain Bird Corporation
P/N: 182193 06AP16EO

You might also like