Toyota Alarm Configuration
Uploaded by
ScribdTranslationsToyota Alarm Configuration
Uploaded by
ScribdTranslationsCorolla 2003
1. Start with the key out of the ignition, the driver's door is
open, all the others are closed and the driver's door is
unlocked.
2. Carry out these steps within 5 seconds.
A. Insert the key into the ignition (DO NOT turn) Pull the key.
B. Insert the key in the ignition (DO NOT turn) Pull the key.
3. Complete these steps within 40 seconds.
A. Close and then open the driver's door.
B. Close and then open the driver's door.
C. Insert the key into the ignition (DO NOT turn) Pull the key.
4. Carry out these steps within 40 seconds.
A. Close and then open the driver's door.
B. Close and then open the driver's door.
C. Insert the key into the ignition and leave it in the on position.
D. Close the driver's door.
E. Turn the ignition to ON (DO NOT start) and then to OFF.
Remove the ignition key.
In 3 seconds, the electric door locks must be locked and
then unlock automatically, indicating a successful entry to
programming mode. Return to step 1 if the locks do not cycle in
this point.
6. Complete these steps within 40 seconds.
A. Press the lock and unlock buttons on the Remote
simultaneously for 1.5 seconds.
B. Immediately after releasing the lock buttons and
unlock, press the lock button only and hold it
pressed for 2 seconds. In 3 seconds, the locks of the
doors must be locked and then unlocked once to
indicate a successful programming. If the door locks
they make a cycle twice, repeat the steps AyBen step 6 already that
the remote control was not accepted.
C. Repeat the stepsAyBen step 6 for each new control