Scribd
Upload
20 views2 pages

Cowl Top Side Inner Panel (Assy) : With The Front Body Pillar Lower Gusset Removed

This document provides instructions for replacing the cowl top side inner panel on a vehicle. It states to remove the front body pillar lower gusset first. It also notes to replace the cowl top side reinforcement at the same time as the cowl top side inner panel. The installation instructions specify to temporarily install the new parts and measure dimensions per the body diagram. It also mentions inspecting the fit of related parts before welding to ensure good appearance, and applying various sealers and coatings after welding.

Uploaded by

Osmar Augusto
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
20 views2 pages

Cowl Top Side Inner Panel (Assy) : With The Front Body Pillar Lower Gusset Removed

This document provides instructions for replacing the cowl top side inner panel on a vehicle. It states to remove the front body pillar lower gusset first. It also notes to replace the cowl top side reinforcement at the same time as the cowl top side inner panel. The installation instructions specify to temporarily install the new parts and measure dimensions per the body diagram. It also mentions inspecting the fit of related parts before welding to ensure good appearance, and applying various sealers and coatings after welding.

Uploaded by

Osmar Augusto
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

BP-14

BODY PANEL REPLACEMENT

COWL TOP SIDE INNER PANEL (ASSY)


REPLACEMENT
With the front body pillar lower gusset removed.

F20985-A

REMOVAL

F20985

POINT
1
Replace the [A] at the same time.
PART NAME
[A] Cowl Top Side Reinforcement

BODY PANEL REPLACEMENT

BP-15

INSTALLATION
S Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension
diagram. (See the body dimension diagram)
S Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the
finish.
S After welding, apply the polyurethane foam to the corresponding parts.
S After welding, apply body sealer and under-coating to the corresponding parts.
S After applying the top coat layer, apply anti-rust agent to the inside of the necked section structural weld spots.

F20986

POINT
1
Inspect the fitting of the front fender and hood, etc., before welding, since affects the appearance of the finish.
PART NAME
[B] Hood Hinge Mounting Reinforcement
[A] Cowl Top Side Reinforcement

You might also like