Like ghcid, but for Elm!

A CLI filesystem watcher that runs elm make automatically and gives you the errors grouped by files, in a collapsible format.

⚠️ Linux only, for now. See issue #1 for details.

$ elmid src/Main.elm

Usage: elmid [--elm-path ELM_PATH]
             [--watched-folder PATH]
             [--ignored-folder FOLDER]
             [--main-cwd PATH]
             MAIN_PATH

If in doubt, run elmid --help.

Have stack installed. Then cloning this repo and running stack build / stack install should be enough.

• MacOS support!!
• watch for creation of new directories and start watching them too
• ellipsis-clamp the path from the left so that the filename is always shown
• debounce
• after successful Elm compiler run, run elm-review too and display its errors similarly
• show the line number in the collapsed view
  • open editor by clicking at the line number: https://tracy.nette.org/en/open-files-in-ide
• check for Debug.log and warn user about them (should still be "All good" even if they're there)