Envoy is a numberpad that can also be built as a 20 key macropad with support for four encoders.
- 20 key macro pad or standard number pad configuration
- Both 3 and 5 pin MX style switches supported
- Hot swap sockets
- Four rotary encoders
- QMK controlled
- Vial firmware
- Easy to solder
- 2 layer PCB
- Switch plate and back plate designs available
- Both throughhole and SMD diodes supported
| Reference | Item | Quantity | Notes |
|---|---|---|---|
| Plates | |||
| PCB | 1 | ||
| Back plate | 1 | ||
| Switch plate | 1 | Technically optional, but recommended. | |
| Components to solder | |||
| D1-D20 | 1N4148 Diode | 21-24 | Both SMD (SOD-123) and through hole (DO-35) supported. |
| U1 | 12x1 male pin header | 2 | For the pro micro. |
| U1 | Pro Micro | 1 | Or pin compatible controller. |
| ENC1-ENC4 | EC11 Rotary Encoder | 4 | |
| Hardware | |||
| Aluminium cone feet | 0 or 2 | If you want to raise the back and tilt the pad towards you. | |
| M2 standoff 8mm | 4 | ||
| M2 x 6mm flat head screw | 8 | Button head screws also work, could go as short as 4mm. | |
| Rubber feet 8mm diameter | 2 or 4 | Only 2 needed if also using the cone feet. | |
| Keys and Knobs | |||
| 2u Stabilizer | 0-3 | One required for each 2u key, 3 for a standard number pad configuration. | |
| MX Switches | 17-20 | ||
| Keycaps | 17-20 | ||
| Encoder knob | 4 | Matching the encoder, max diameter 18mm. |