Low cost digital dashboard to connect to speeduino ECU via Serial 3

Project I developed to weigh all 4 corners of a vehicle using esp32's, hx711's, and load cells and presenting those measurements on webpage.

LED system compatible with MoonBoard based on Arduino Nano 33 BLE

riocore

RealtimeIO for LinuxCNC based on an FPGA

Plans and such for my CNC plasma project, https://www.runstenracing.se/?cat=61

Open Source TS Compatible ECU Tuning Software

k8s operator for Flyway migrations

Sherpa Zero: Voron Issue #6, Prusa3d Issue #602 Mitigator

High Temperature Voron V0 for PEI, PEEK ...

Hardware - dingoPDM is an open source, affordable automotive PDM (Power Distribution Module). Pre-assembled and tested units are available or the design can be used to build a DIY version.

Polygonus - Brain board for FOME ecus

OpenPDM is an open-source programable Power Distribution Module for your car

Project to provide functionality similar to ESPHome but for Zigbee instead of WiFi for nRF52, nRF53 & nRF54L

Interval Tree Clock

8Ch EGT sensor board to be used with aftermarket ECUs

blitzBOX - low-cost and mini-sized ECU for speeduino firmware (45 x 58 mm)

An Arduino library for sending and receiving data using CAN bus.

CAN-bus gauge cluster for BMW E12

Luxtronik integration for Home Assistant

Lathe electronic leadscrew controller

Let's upgrade cheap off-the-shelf robotic mowers to modern, smart RTK GPS based lawn mowing robots!

Mainsail is the popular web interface for managing and controlling 3D printers with Klipper.

Dynamic serial plate creator for Voron printers

A dash project for tunerstudio based on RASPBIAN