Serial driver and command line tool for Alicat mass flow controllers.
If you are using Analyt-MTC flow controllers, go to this repository for more info.
pip install alicat
If you don't like pip, you can also install from source:
git clone https://github.com/numat/alicat.git
cd alicat
python setup.py install
For basic tasks, this driver includes a command-line interface. Read the help for more.
alicat --help
For more complex projects, use python to automate your workflow.
from alicat import FlowController
flow_controller = FlowController(port='/dev/ttyUSB0')
print(flow_controller.get())If the flow controller is communicating on the specified port, this should return a dictionary of the form:
{
'flow_setpoint': 0.0, # Mass flow setpoint
'gas': 'Air', # Can be any option in `flow_controller.gases`
'mass_flow': 0.0, # Mass flow (in units specified at time of purchase)
'pressure': 25.46, # Pressure (normally in psia)
'temperature': 23.62, # Temperature (normally in C)
'total_flow': 0.0, # Optional. If totalizer function purchased, will be included
'volumetric_flow': 0.0 # Volumetric flow (in units specified at time of purchase)
}You can also set the gas type and flow rate.
flow_controller.set_gas('N2')
flow_controller.set_flow_rate(1.0)You can have multiple controllers on the same port.
flow_controller_1 = FlowController(address='A')
flow_controller_2 = FlowController(address='B')
flow_controller_1.set_flow_rate(1.0)
flow_controller_2.set_flow_rate(0.5)
flow_controller_1.close() #/dev/ttyUSB0 is still open!
flow_controller_2.close()