X-Ray machine controller built in C++ on Raspberry Pi, featuring modular drivers for I2C, UART, Modbus, GPIO, motor control with encoder polling, and a PID controller, all wired together with RAII-based resource management.
Smart Street Lighting & Smart Traffic Light: Arduino‑based IoT system for adaptive lighting and traffic control.
Bu projede UART iletişim protokolü arduino kullanılarak örnek bir proje ortaya koyulmuştur.
Autonomous hexapod rescue robot with thermal sensing, real-time face detection, and GPS tracking for earthquake response.
An arduino library for the GPS sensor,very simple and intuitive to use to use the library--> copy the GPS file to arduino--> libraries
A Deterministic Multi-Node Communication System using SoftwareSerial
Hello Recognize本是EasyPR的android移植版本，本项目旨在提升原版效率，修正bug，同时加入了UART通讯。
I have implemented UART Communication Protocol in IoT using Arduino Uno and LoRa Module
Atari 8-bit SIO Disk Drive Emulation by Arduino and python backend.
This project aims to build a DIY Stream Deck for a fraction of the cost, and enhance my knowledge of UART, USB and freeRTOS.
Simple MIDI controller for Kemper Amplifier with a pico (5 Pin MIDI w/ UART)
A UART device emulator written in C++ without the standard library.
APASerialSync: The Ultimate Zero-Copy Data-Sync Engine for Arduino
Prototype system for monitoring following distances between vehicles and detecting tailgating violations in real time.
This code is for the Forest Rover GATEWAY which sends realtime sensor values to the Firebase database on receiving sensor data from the Forest Rover vehicle node through the NRF24L01 module.
A modular Arduino-based plant irrigation system that uses UART serial communication to send soil moisture data to a Python desktop interface (alternatively C# windows forms application). Built with C++ libraries for clean embedded design.
A GPS module ESP32 test development firmware to test out any old/new modules via UART using arduino software
Coursework of microprocessor & microcontroller
To associate your repository with the uart-protocol topic, visit your repo's landing page and select "manage topics."