A driver for ublox gps

Arduino library for the fastest and simplest communication with u-blox GPS modules

ROS2 drivers for U-blox ZED F9P

Arduino and CMake library for communicating with uBlox GPS receivers.

Extended Kalman Filter predicts the GNSS measurement based on IMU measurement

A GPS setup to log your track lap times, based on ESP32, with the ability to interface with several mobile phone apps that log your speed and position via Bluetooth Low Energy, Bluetooth or WiFi

Ublox Linux Library

u-blox GNSS receiver library light weight for low power tracking application

Software for a Raspberry Pi based muon detector system of the MuonPi project.

eCAL interface to the linux gps service daemon

Time interval counter based on TI TDC7200 chip with GPS modules for precise time standard comparison.

Example of the UBlox driver using a STM32 microcontroller

An Arduino-based GPS tracking solution. Uses one Arduino as the GPS tracker and the other to display the GPS location.

This is a project I'm working on so I can have cruise control in my car. It uses GPS in order to monitor the speed of your vehicle, and shows your speed on the OLED display. It allows you to set your desired speed limit using two push buttons. If you speed, the device screams - the pitch changing with your speeding.

GNSS library for Ublox C030-412m board with ZOE-M8B chip.

Sparkfun UBX GNSS Receiver monitor utility for ESP32 and VSCode / PlatformIO

Telemetry Tracking & Reporting System

Simple driver for uBLOX-LEA-6S GPS's using termios

Ublox GPS I2C async library for mbed

the tiny-gps library for working with U8 / UBX-m8030 gps devices with arduino,