60 Watts

AC-DC
xppower.com

ECP Series
• Low Profile Design

• Compact Size, 4” x 2”

• IT & Medical Approvals

• Dual and Triple Output

• <0.5 W No Load Input Power

• Peak Load Capability

• 3 Year Warranty

Specification
Input General
Input Voltage • 85-264 VAC, derate from 100% load at Efficiency • 88% typical at 230 VAC and full load
90 VAC to 90% load at 85 VAC Isolation • 4000 VAC Input to Output
Input Frequency • 47-63 Hz 1500 VAC Input to Ground
Input Current • 0.85 A max at 115 VAC 500 VDC Output to Ground
Inrush Current • 100 A max at 230 VAC, cold start at 25 °C Switching Frequency • 30-130 kHz variable
Power Factor • EN61000-3-2, class A MTBF • >400 kHrs to MIL-HDBK-217F
No Load Input Power • <0.5 W at 25 °C, GB
Earth Leakage Current • <250 μA at 264 VAC, 60 Hz
Input Protection • Internal T2 A/250 V fuse in both
Environmental
line and neutral Operating Temperature • -20 °C to +70 °C, derate from 100% load
at 50 °C to 50% load at 70 °C
Output Cooling • Natural convection
Output Voltage • See table Operating Humidity • 5% to 95% RH, non condensing
Output Voltage Trim • ±10% on V1 only, output 2 on multi output Operating Altitude • 3000 m max
models will track by the same percentage Storage Temperature • -40 °C to +85 °C
Minimum Load • 10% minimum load required on all Shock • 30 g pk, half sine, 6 axes
outputs of multi output models Vibration • 2 g rms, 5 Hz to 500 Hz, 3 axes
Start Up Delay • 1.3 s max
Start Up Rise Time • 15 ms typical EMC & Safety
Hold Up Time • 16 ms min at full load at 115 VAC Emissions • EN55011/32, level B conducted & level A
Total Regulation • Output 1: 2% from 0% load to 100% load radiated
Output 2: 5% from 20% load to 100% load Harmonic Currents • EN61000-3-2, class A
Output 3: 5% from 10% load to 100% load Voltage Flicker • EN61000-3-3
Transient Response • 4% max deviation, recovering to less than ESD Immunity • EN61000-4-2, ±4 kV indirect contact,
1% within 500 μs for 50% step load Perf Criteria A
change at 1 A/μs
Radiated Immunity • EN61000-4-3, 3 V/m, Perf Criteria A
Ripple & Noise • 1% pk-pk measured with 20 MHz
bandwidth EFT / Burst • EN61000-4-4, level 3 Perf Criteria A
Overvoltage Protection • 115-140% of nominal output voltage Surge • EN61000-4-5, level 2 Perf Criteria A
on V1 only, recycle input to reset Conducted Immunity • EN61000-4-6, 3 V Perf Criteria A
Overload Protection • 120-160% of nominal power Dips & Interruptions • EN61000-4-11, 30% 10 ms, 60% 100 ms,
100% 5000 ms, Perf Criteria A, B, B
Short Circuit Protection • Trip and restart (hiccup mode)
EN60601-1-2, 30% 500 ms, 60% 100 ms,
Temperature • ±0.02%/°C max 100% 10 ms, 100% 5000 ms,
Coefficient Perf Criteria A, A, A, B
Safety Approvals • UL62368-1, IEC62368-1, EN62368-1,
ANSI/AAMI ES 60601-1, IEC60601-1,
EN60601-1, CE & UKCA meets all
applicable directives & legislation.
 AC-DC
Models and Ratings ECP60
Output Output 1 Output 2 Output 3
Model Number
Power Voltage Current Peak(1) Voltage Current Peak(1) Voltage Current

60 W +5.0 VDC 7.0 A 9.1 A +12.0 VDC 3.0 A 3.90 A ECP60UD01

60 W +5.0 VDC 7.0 A 9.1 A +15.0 VDC 2.0 A 2.60 A ECP60UD02

60 W +5.0 VDC 7.0 A 9.1 A +24.0 VDC 1.5 A 1.95 A ECP60UD03

60 W +5.0 VDC 7.0 A 9.1 A +15.0 VDC 2.0 A 2.60 A -15.0 V 0.30 A ECP60UT02

60 W +5.0 VDC 7.0 A 9.1 A +24.0 VDC 1.5 A 1.95 A -12.0 V 0.30 A ECP60UT04

Notes
1. Peak load lasting <30 s with a maximum duty cycle of 10%, average output power not to exceed nominal.

Mechanical Details

4.00 (101.6)

3.75 (95.2)
Voltage Adj.
CN1 - Input Connector
Pin 1 Neutral
Pin 2 Not Fitted 1
1 CN3
Pin 3 Line
CN2 6
Mates with JST housing 2.00
VHR-3N and JST Series (50.8) CN2
SVH-21T-P1.1 crimp terminals 6
1.75
3 1.75
Mounting holes marked with (44.4)
1 (44.4)
must be connected to safety earth CN1
1

CN2 Output Connector

UD/UT US05
0.13 ±0.01 (3.4 ±0.3)
UD/UT
Mounting hole need to be isolated from ground
Pin 1 V2
Pin 2 V1
Pin 3 V1
Pin 4 RTN
Pin 5 RTN 1.04 1.20
Pin 6 V3 (26.3) (30.4)
Mates with JST housing
VHR-6N and JST Series
SVH-21T-P1.1 crimp terminals

0.06 (1.6) 0.1 (2.5)

Notes
1. All dimensions are in inches (mm). 3. Tolerance: ±0.02 (±0.5) unless stated
2. Weight: 0.34 lbs (155 g) approx.

Derating Curve
100

80
Output Power (%)

60

40

20

0
-20 -10 0 10 20 30 40 50 60 70 80
Ambient Temperature (ºC)

05 Feb 2024