tm4c123gxl

This repository contains all my practice codes of TM4C123GXL coded in CCS7. The Texas Instruments Tiva C LaunchPad board TM4C123G is used for the code. The TM4C123GXL Launchpad has the TM4C123GH6PM microcontroller which is based on the ARM Cortex-M4F microcontroller architecture and clocked at 80 MHz (with 100 DMIPS)

Minimal TCP/IP stack for non OS based micrcontroller enviornment.

Written in Code Composer Studio and tested on Tiva C Series TM4C123G LaunchPad.

Tiva C: UART, I2C, SPI, SSI

Tutorials for the Tiva C Series TM4C123G Launchpad.

Driver library for the TM4C123GH6PM Microcontroller

A variety of helper functions, driverlib, and sensorlib rewrites to facilitate easier programming of the TI TM4C microprocessors.

This repository contains all my practice codes of TM4C123GXL coded in IAR Workbench. The Texas Instruments Tiva C LaunchPad board TM4C123G is used for the code. The TM4C123GXL Launchpad has the TM4C123GH6PM microcontroller which is based on the ARM Cortex-M4F microcontroller architecture and clocked at 80 MHz (with 100 DMIPS).

Programmed in C using Keil IDE with ARM Cortex architecture

The following is a HID 15 button arcade stick with an LCD Screen. The tm4c123gxl microcontroller is used for this project.

Light weight wireless messaging protocol for low power sensor network, based on slotted aloha access method.

Bare metal lessons on Tiva TM4C123GXL

Experimental comparison of bit-banding and read-modify-write on the TM4C123GXL, measuring cycles, .text size, and interrupt safety.

A (potato-y) portable game console made using the TM4C Launchpad, duct tape, and magic.

TivaC (TM4C1294NCPDT and TM4C123GH6PM) Template Project (CMakefile)

Two TM4C123GXL boards transmit UART text over infrared by modulating the data onto a 38 kHz PWM carrier for a TSOP134 IR receiver. Uses simple logic gating + a transistor driver to send, receive, and print messages back to a PC terminal.

The following is an unbeatable tic-tac-toe game using the tiva TM4C123GXL microcontroller.

The following is a HID 16 button arcade stick. The tm4c123gxl microcontroller is used for this project.

Servo Motor is Programmed Through Tiva C Launchpad to press a button on Electric Board

In this lab we design microcontroller-based embedded systems for various applications. Topics covered include interfacing to sensors and actuators from both hardware and software perspectives, assembly and C programming for embedded systems I/O, real-time design, and interrupts. In addition, we implement and evaluate a complete embedded system.