ELECTRICAL NOTES

1. ALL ELECTRICAL WORKS AND INSTALLATION SHALL COMPLY WITH THE PROVISIONS OF THE LATEST EDITION OF THE PHILIPPINE ELECTRICAL CODE WITH
THE RULES AND REGULATIONS OF THE NATIONAL AND LOCAL AUTHORITIES CONCERNED. N
LOAD SCHEDULE
2. SERVICE VOLTAGE TO THE UNIT SHALL BE 230 VOLTS, 60 HERTZ, SINGLE PHASE.
3. THE CONTRACTOR SHALL VERIFY AND ORIENT THE ACTUAL LOCATION OF CONCRETE TERMINAL POLE FOR CONNECTION TO THE POWER SUPPLY. DESIGNATION: P1
4. ALL INSTALLATION SHALL BE CONCEALED FROM VIEW, WIRING SHALL BE IN CASE IN POLYVINYL CHLORIDE (PVC) PIPE SCHEDULE 40 EXCEPT POWER
AND TELEPHONE SERVICE WHICH SHALL BE RIGID STEEL CONDUIT (RSC) OTHERWISE NOTICED. ENCLOSURE: NEMA 1
5. PULL BOXES OF APPROPRIATE SIZE SHALL BE PROVIDED, EVEN IF NOT INDICATED IN DRAWINGS TO ACCOMMODATE THE NUMBERS OF SPLICES OF WIRES. MOUNTING: MSURFACE MOUNTED
6. ALL MATERIALS TO BE USED SHALL BE NEW AND OF APPROVED TYPE APPROPRIATE FOR BOTH LOCATION AND INTENDED USE. 2 VICINITY MAP
E1 SYSTEM: Single Phase/230V Normal power- 80 Ampere
7. SWITCHES SHALL BE INSTALLED 1.40 MTS. FROM FINISH FLOOR AND CONVENIENCE OUTLETS AT 0.30 MTS. COUNTER TOP OUTLETS SHALL BE INSTALLED
LOAD IN
0.20M IN HEIGHT FROM COUNTER TOP FINISH. CKT. DESCRIPTION AT AF VOLTS WATTS WIRE
8. RANGE OUTLET, AIRCON OUTLET, & LAUNDRY OUTLET CIRCUIT SHALL BE PROVIDED WITH A GROUNDING WIRE. 1 LIGHTS & OUTLET 20 100 230 1900 2-3.5 mm² THHN + 1-3.5 mm² THHN GND
9. ELECTRICAL INSTALLATIONS SHALL BE UNDER THE DIRECT SUPERVISION OF A DULY LICENSED ELECTRICAL ENGINEER, OR A REGISTERED
PROFESSIONAL ELECTRICIAN. 2 CONVENIENCE OUTLETS 20 100 230 720 2-3.5 mm² THHN + 1-3.5 mm² THHN GND

10. NO REVISION IN THE DESIGN SHALL BE DONE WITHOUT THE PRIOR KNOWLEDGE & APPROVAL OF THE DESIGNER AND THE OWNER, ANY SUCH REVISION 3 CRYO 360/7DHIFU 20 100 230 2800 2-3.5 mm² THHN + 1-3.5 mm² THHN GND
DONE W/O APPROVAL SHALL CAUSE RESPONSIBILITY OF THE DESIGNER TO CEASE AS A WHOLE.
11. CONDUIT TO BE USED MUST BE RSC/IMC FOR MAIN AND EMT MAYBE ALLOWED FOR BRANCHES PROVIDED IT IS NOT INSTALLED ON EXPOSED LOCATION. 4 EMSCULPT 20 100 230 2800 2-3.5 mm² THHN + 1-3.5 mm² THHN GND

5 COOLWAVE 20 100 230 650 2-3.5 mm² THHN + 1-3.5 mm² THHN GND

6 COCOON 20 100 230 2800 2-3.5 mm² THHN + 1-3.5 mm² THHN GND

7 AUXILIARY PROVISION 20 100 230 1000 2-3.5 mm² THHN + 1-3.5 mm² THHN GND
8110 8110
8 FCU 30 100 230 3000 2-3.5 mm² THHN + 1-3.5 mm² THHN GND
2550 3255 2300 2550 3255 2300
1955 1300 1955 1300 9 FCU 30 100 230 3000 2-3.5 mm² THHN + 1-3.5 mm² THHN GND

TOTAL 18670
LOAD CALCULATION
Single Phase, 230V, 80 AT, BOLT-ON CB use 30mm VOLTAGE DROP ANALYSIS:
wire

P
5
COOLWAVE
1840

1840
12 11

9
10

3475

3475
8 7
S(9,10) EMSCULPT
9 S(11,12) CRYO360/7D P
11 4 4 PANEL LOAD SCHEDULE & CALCULATION
P
6
3 CO E1
12
3205

3205
CO
S(7,8)

10
14 LEGEND:
CO
7 TYPE AND COLOR AS PER ARCHITECT /
13 CLIENT'S APPROVE SAMPLE.
6 6 6
CO CO COCOON
S(13,14)
9750

9750

9750

9750
8 LED PIN LIGHT (DAYLIGHT)
P
3225

3225
6
P LED DECORATIVE PENDANT LIGHTING

2
COVE LIGHTING
13
6 6
(15,15A) S
2200

2200
S
(1,2,3)
S
(4,5,5A) 14 PANEL BOARD
15 S
(6) 1 30 A 20 A 2
15A 5A CO CIRCUIT HOMERUN
3 20 A 20 A 4
550

550
3 20 AT, 2P
4 4 4 4
5 20 A 20 A 6
5 P
S(16,16A) 5
CIRCUIT NO.
800

800
7 20 A 20 A 8

CO
4 4 4 9 20 A
3050

3050
CO CONVENIENCE OUTLET

CO
2500

2500

CO X INDICATED FOR EQUIPMENT MTS

1700

1700
3
4 4 4 4
TOILET EXHAUST OUTLET
80 AT
16A P 16 3
1 2 1 2
TO TAPPING POINT
GENSET

BUSBAR
GUTTER
4310 1840 610 4310 1840 610
1350 6760 1350 6760
8110 8110

5 SINGLE LINE DIAGRAM

3 LIGHTING AND SWITCH LAYOUT 4 POWER & AUXILIARY PLAN E1
SCALE 1:50M (20X30) 1:100 (A3) SCALE 1:50M (20X30) 1:100 (A3)
E1 E1

AR.GIAN ELLA C. SELOM CERTIFIED BY: PROJECT TITLE: OWNER: PREPARED BY: SHEET CONTENT: DRAWING INFO: SHEET NO:
REPUBLIC ACT NO. 9266 THIS DRAWING AS AN INSTRUMENT OF SERVICE IS THE
PROPERTY OF THE S DESIGN CLIQUE, IT MUST NOT BE IN PART OR IN WHOLE PERMIT DATE : REMARKS:
ANYONE TO COPY OR DUPLICATE SAID DOCUMENT WITHOUT PERMISSION.

else REPUBLIC ACT NO. 8293 "PROTECTION OF INTELLECTUAL PROPERTY" WORKS OF

ART, ARCHITECTURE, MODELS & DESIGNS ARE CREATIVE WORKS AND CONSIDERED
PROPOSED INTERIOR FIT-OUT
BELLUS CLINIC
CHECKED BY:
DATE : :
AS SHOWN
E1

D E S I G NS AS INTELLECTUAL PROPERTIES OF ITS CREATOR, ARCHITECT, ENGINEER OR AUTHOR.

-- REVISION NO. : N/A DESIGN BY: else
APPROVED BY:
FOR DRAWINGS & DESIGN CLARIFICATIONS OR INQUIRIES, REACH US AT:
0998-887-7553 / ELSEDESIGN.ARCH@GMAIL.COM LOCATION: Entrata Urban Complex, 2609 Civic Dr, Filinvest City Alabang, Muntinlupa, 1781 Metro Manila DATE : DATE: APRIL 2023