Acta Forestalia Fennica no. 249 | 1995
Category : Article
In the first part of the study, the selected wood and fiber properties were investigated in terms of their occurrence and variation in wood, as well as their relevance for thermomechanical pulping process and related end-products. It was concluded that the most important factors were the fiber dimensions, juvenile wood content, and in some cases, the content of heartwood being associated with extremely dry wood with low permeability in spruce. The following pulpwood assortments of which pulping potential was assumed to vary were formed: wood from regeneration cuttings, first-thinnings wood, and sawmill chips.
In the experimental part of the study, the average wood and fibre characteristics and their variation were determined for the raw material groups. Subsequently, each assortment – equalling about 1,500 m3 roundwood – was pulped separately for 24 h period. The properties of obtained newsgrade thermomechanical pulps were then determined.
Thermomechanical pulping (TMP) from sawmill chips had the highest proportion of long fibres, smallest proportion of fines, and had generally the coarsest and longest fibers. TMP from first-thinned wood was the opposite, whereas that from regeneration cuttings fell in between these two. High proportion of dry heartwood in wood originating from regeneration cuttings produced a slightly elevated shives content. However, no differences were found in pulp specific energy consumption. The obtained pulp tear index was clearly the best in TMP made from sawmill chips and poorest in pulp from first-thinned wood, which had generally inferior strength properties. No big differences in any of the strength properties were found between pulp from sawmill residual wood and regeneration cuttings. Pulp optical properties were superior in TMP from first-thinnings. No noticeable differences were found in sheet density, bulk, air permeance or roughness between the three pulps.
The most important wood quality factors were the fibre length, fibre cross-sectional dimensions and percentage juvenile wood. Differences found in the quality of TMP assortments suggest that they could be segregated and pulped separately to obtain specific product characteristics and to minimize unnecessary variation in the raw material and pulp quality.
-
Tyrväinen,
E-mail:
jt@mm.unknown