 |
| Old Fritz |
The first step after PVAing the figures to the combination MDF and steel bases was to texture the bases. I used a cocktail stick to apply PVA not only to the MDF surface but also onto the figure bases and around the figures' ankles. This is essential to hide the figure bases. I then poured over a mixture of bird sand and model railway ballast, shook it off, and repeated the application. (For 15mm figures I build up the bases with filler and then apply PVA. For 6mm figures I use bird sand without the ballast.)
As the figures for this project are packed very closely together, it wasn't possible to get right to the centre of the bases. This doesn't matter as this area will end up dark brown representing deep shadow.
With the figures so tightly packed, the ArmyPainter spray undercoat (Leather Brown) also didn't get between the figures too well so I had to go over them with a generous wash of matching AP bottle paint.
 |
| A unit of Prussian Musketeers based, textured and undercoated. |
I thought I'd have to add some coat colours before rendering the figures distinguishable and thus usable on the table, but I've now added temporary labels to tell the armies apart and to keep the appropriate bases in each unit together. I'm very glad I've never dropped these or muddled them up as it would have been a very tedious job to distinguish, for example, Prussian, Austrian and Hungarian line infantry.
 |
| The unit duly identified from the rear. |
For the benefit of those who haven't seen earlier postings, these are 10mm Pendraken figures for use with
Maurice or maybe
Might & Reason.