Mekboy Junka 35 - And done...

...I hope.

As promised I gave the Junka a quick spray of grey primer to bring everything together and to highlight anything that may need to be done.

As far as I can see there isn't. I added the extra couple of magnets to the SAG turret but otherwise nothing has changed on the Junka since the last time.

So here is the picture dump...

Fingers crossed the customer is happy with it and I can get it boxed up and shipped out...

I admit at times it has been a struggle to get this done, I do these commissions for the joy of building something Orky, but I think I have now reached the limit where it has become more of a chore to get done than something to so because I enjoy doing it.

As such this is going to be the last commission for a while at least. I am going to get some Orks done for myself now (the Zone Mortalis force) and after that I shall be a Green Free zone for the rest of the year at least. My time can go towards my own projects like getting the Militia sorted and the ZM board painted. Oh and the rest of my Nurgle Daemons painted.

Mekboy Junka 34 - Almost there...

So the Junka is on the verge of being finished.

Tomorrow (weather dependant) I want to give it a quick coat of grey primer to bring it all together and help spot anything I may have missed.

Since the last update I've done a few things...

Deff Rolla -

I've glued the Rolla into the one support arm and added a brass pin to the other one. The has made the whole thing much more stable and also allowed the Rolla to be fixed in the one position allowing me to add the spikes.

All those spikes were cut from Kan & Dredd shoulder pads. Quite a lot of them. I have a few more in the post so when they arrive i'll add the last few spikes.

The Junka can be handled easily now without the Rolla moving, it's nice and stable.

Shown below is the Ork Glyph I added to the plain area beside the drivers cab.

Shokk Attack Gun Turret - 

I added the last two arms on the front and also finished the Snotling box on the back.

The Glyphs on the rear are "Runt" for Snotlings (on the left) and "Shokka" the glyph for a Shokk Attack Gun.

And some pictures of the whole vehicle:

Note in the pic above you can see the exhaust on the back has been added. Had to go with that one as the others got hit by the SAG turret as it turns.

And the parts break down like this:

Mekboy Junka 33

This week has been pretty crap. Work has been a bitch so I've had very little time to do anything.

However what time I have managed has gone onto the Junka SAG turret. It may not look like it has progressed a lot but there is about 3-4 hours work gone into just this turret.

Still need a few details and also the remaining two prongs of the SAG. The Snotling tank is also missing, but I have made a start...

Everything put together including the WIP Snotling tank.

More to do. I am away this weekend but next week I hope to get the turret finished along with the remaining hull details (like that blank bit on the front). Still have the spikes on the Rolla to do.

Hopefully I'm now on the final run to getting this finished...