3D Printed: Pulp Alley Solo Deck Holder

Yesterday, I printed a deck holder for my recently acquired Solo Deck (plus boosters). I also got Tomb of the Serpent with that order from Sally 4th, and I really should be ploughing through it, instead of posting this... 😏

Card Holder for X-wing and Armada

Over a year ago, I designed this card shoe/holder for damage cards that fits FFG's 'Yellow' card sleeves exactly.

I was getting frustrated by the cards tilting and spreading, and thus made a card holder out of cardboard, but I did not like it that much, although it did get the job done, so I started dabbling in 3D-design - and now, as I have got my new Creality GR10S S3 up and running, it was time to try printing it, and you can see the result to the left (I have nor removed the 'skirt', yes, seen along the back edges).

I printed it lying on its back to avoid supports, but I am going to to make another one standing upright with supports for the 'shelf', so that I may compare the two methods.

My Printer is Working!!

The problem turned out to be the tiny screw on top of the extruder arm that was too tight.

Now I am printing an extra barricade for Star Wars Legion (just because), found here on Thingiverse.

I am as thrilled today, as I was frustrated yesterday!

My Newest Toy...

I have got a shiny new toy - and cannot get it to work!!! 😡😡😡😡😡😡😡😡

From I started unpacking I have been working on that blasted thing for about five hours - half of the time trying to figure out why it stops extruding filament after the first few layers, and trying different settings to mend it, without any results to show other than some thin stands of PLA...

I am deeply frustrated... 😫